Can you use T8 LED bulbs in a T12 fixture?
The main difference between T8 and T12 tubes is the tube’s diameter. T12 tubes are 1.5″ in diameter while T8s are just one inch. All other things—socket sizes, lengths, distance between pins—are the same. T8 LED tubes won’t fall out if you try to install them in a T12 fixture—they’ll fit just fine.
Can a T8 tube replace a T12?
The easiest and lowest price option to replace a T12 is a T8 linear fluorescent. They have become the go-to option for pre-existing T12s. If you still have magnetic ballasts, switching to a T8 will require a ballast swap.
Can you replace a T8 fluorescent bulb with an LED bulb?
Yes, you can replace fluorescent tubes with LED tubes or LED integrated fixtures. … As long as the bulb is compatible with the existing fluorescent ballast in the fixture, you simply remove the fluorescent and replace it with the LED tube light.
Are T8 or T12 bulbs brighter?
The Standard T12 lamp produces 2,650 initial lumens per lamp. The standard T8 produces 2,800 initial lumens per lamp, 6% brighter. But the standard T12 lamp produces 2,300 design lumens and the T8 produces 2,660 design lumens. … Design Lumens are the average lumen output of the lamp after 40% of its rated life.
Are T8 fluorescent bulbs being discontinued?
Even some T8 lamps have been phased out. US Congress has enacted legislation to prohibit the manufacture of these and other inefficient lighting technologies, and is calling for manufacturers to meet minimum efficiency requirements and lumens per watt for new products.
How do I convert T12 fluorescent to LED?
If you’re converting your existing T12 lamps to LED, you have six options to choose from:
- Install ballast-bypass linear LED lamps. …
- Install plug-and-play magnetic and electronic ballast-compatible linear LEDs. …
- Install electronic ballast-compatible linear LEDs and a new electronic ballast.
Do I need to remove the ballast to use an LED bulb?
A plug and play LED is a fixture where you can install LED bulbs to what was once a fluorescent bulb. This is an easy solution and requires minimal effort on your part. Since it works with the existing ballast, there is no need for rewiring or ballast removal.