Can LED lights be used in fluorescent fixtures?

Can you put LED bulbs in fluorescent fixtures?

To convert a fluorescent light fixture to use LED bulbs, you can either use LED bulbs that are compatible with the existing fluorescent ballast (plug-and-play tubes) or you can rewire the fixture to bypass the ballast and replace with sockets with non-shunted lampholders.

Do I need to remove the ballast to use an LED bulb?

A plug and play LED is a fixture where you can install LED bulbs to what was once a fluorescent bulb. This is an easy solution and requires minimal effort on your part. Since it works with the existing ballast, there is no need for rewiring or ballast removal.

Can you use T8 LED bulbs in a T12 fixture?

The main difference between T8 and T12 tubes is the tube’s diameter. T12 tubes are 1.5″ in diameter while T8s are just one inch. All other things—socket sizes, lengths, distance between pins—are the same. T8 LED tubes won’t fall out if you try to install them in a T12 fixture—they’ll fit just fine.

Will ballast compatible LED tubes work without a ballast?

If the LED tube is not compatible with your ballast, you would then need to replace your ballast in addition to the T8 LED tube. … The T8 LED tube won’t work without the ballast, so you are forced to continue buying and replacing ballasts as long as you have an LED tube that is ONLY ballast dependent.

IT IS AMAZING:  Do all smart bulbs work with Alexa?

Can a fluorescent light work without a ballast?

In a fluorescent lighting system, the ballast regulates the current to the lamps and provides sufficient voltage to start the lamps. Without a ballast to limit its current, a fluorescent lamp connected directly to a high voltage power source would rapidly and uncontrollably increase its current draw.

Why dont LED lights need a ballast?

A ballast regulates the current that’s coming at a lamp. It gives an initial burst just to get things going, then it makes sure the electric current is controlled and steady. Not getting the lamp’s shoes all wet. A ballast for Light Emitting Diode (LED) lights is not required – instead a driver is required.