# Can you connect two LED strips together?

Contents

## How do you connect two LED strips to one power source?

In order to do two equal parts, you should run two strips at 30 feet each. Run the first strip straight from the power source. Run a parallel set of wires to the point where the first strip ends to feed the second strip with power.

## Can you overlap LED strips?

During installation, make sure flexible light isn’t receiving electricity in any manner. C) Make sure the voltage marked on your light strip matches the LED Driver. D) Do not overlap this product as the overlapping may cause the flexible light to overheat and melt or ignite.

## How many feet of LED strips can you connect together?

This is no different with LED strips. Vetco recommends, as a general rule, not to connect more than three complete strips end-to-end without adding in extra, higher gauge power wire or additional power supply units down the line.

## How do you solder two LED strips?

Getting Started: Soldering Leads Onto LED Strips

1. Strip off about 2-3mm leaving the copper on your wires exposed.
2. Apply heat and solder simultaneously to the bare copper making sure that you don’t apply too much heat.
3. Dab off solder onto the bare copper pads on the strip. …
4. Let them cool off.
IT IS AMAZING:  Why does my light bulb smell burnt?

## How many LED lights can be connected?

1440/100= 14.4. Therefore, your circuit can only handle 14 incandescent light strings connected together. On the other hand, if an average LED string light set uses 10 watts, then 1440/10=144. That means you can have 144 light strings connected together if they’re LED!

## How many 5050 LED strips can you connect together?

You can connect up to 2 16ft 5050 ribbons. If you do more the lights become dimmer. With 60 watts you have to take into account that each foot of LEDs use ~2 watts.

## Should LED be connected in series or parallel?

In short, wiring in series divides the total power supply between the LEDs. Wiring them in parallel means that each LED will receive the total voltage that the power supply is outputting.